RS-485 Proximity Card Reader
Product Code: SSR-201
Key Features
Note:
This unit is designed to suit smaller installations and does not support features like multi-dropped controllers, expansion boards or events across controllers.
If you require any further information, please contact our sales department…
- High-bright, Tri-colour LED
- Audible buzzer with different allow and deny sounds
- Industry standard 125khz operational frequency
- Reads Hitag™ 1, Hitag™ 2, EM4102 card technologies
- Rotary coded address switch for easy addressing
- Configurable bitmasking for limiting card number length to 16, 24 or 32 bits
- RS485 or OSDP communications
About the product
The SSR-201 RS-485 Proximity Card Reader from Saflec Systems is a reliable, secure, dependable, and cost-effective access control solution for various applications.
It communicates via our proprietary RS-485 and/or OSDP protocol, which ensures data transmission over long distances while maintaining high levels of security and reliability.
The reader supports multiple card technologies and offers easy-to-use configuration in our SACS software interface, enabling efficient access control to restricted areas while maintaining the safety and security of personnel and assets.
Advanced encryption algorithms protect data transmitted between the reader and access controllers from interception and tampering.
The SSR-201 features an attractive yet robust ABS plastic housing.
Installation
There is a label on the inside of the cabinet door that clearly shows the connections for readers, inputs & outputs. The unit has dual-mode relays that can be set as powered outputs or potential-free relays (using the indicated jumpers) that allow you to switch any lock or electrical device.
The Controller/s communicates with the SACS Server via the standard TCP/IP protocol of a LAN/WAN using the onboard RJ45 connector. The controllers can also connect to 15 additional controllers via its’ RS-485 controller network. The unit can be configured to use a DHCP-assigned IP Address or be given a fixed/static IP address (recommended). The initial IP Address settings are done via the onboard OLED Display on the controller and, once communication is established, the access control configuration of the doors, reader, etc. is done using the SACS Software.
There are diagnostic LEDs mounted close to their relevant terminals to assist with trouble-free installation. End-of-line resistors can be switched into the circuit as required using the indicated jumpers. External terminating resistors are not required.
Operation
Any changes made at the PC are immediately communicated and stored at the controller. When a user presents their card to the reader, the controller identifies them and permits or denies access as appropriate.